dolcnccar

Milled Delta Carriage

Posted by / Uncategorized

I’ve done two posts recently on how to use DolphinCam with the lathe.  I finally got around to using it with the mill.  I’ve included similar screenshots as before.  This time there are a few more profiles to worry about.

This one presented a bit of a dilemma.  I wanted to cut it out of a piece of aluminum that was a bit bigger than the part.  At the same time, I didn’t have a good way to hold down the center once cut.  I used the created tabs easily in the software which made it much easier.  You can see them in the iso view below.

Tagged With: ,